Redline Communications RDL-2000 Manual do Utilizador descarregar pdf (Página 14)

RDL-2000 User Manual

Notes:

1. Ethernet port 1 is factory sealed. Do not removed the factory seal unless both

Ethernet ports are required for this deployment (see following notes).

2. The two Ethernet ports connect to a si ngle internal switch and connection of both

ports to external network equipment must be configured to avoid layer 2 loops.

3. The dual Ethernet ports can also be used to implement a full-redundancy (data +

power) solution. Use a standard Ethernet crossover cable to interconnect two RDL-

2000 units. Power from a PoE connected to either unit is conducted over the

interconnecting cable.

2.2 RF Ports

The RF ports (2x female TNC connectors) conduct RF signals between the RDL-2000

and external antenna system. RF Port 0 is always enabled and should be used if

operating in SISO mode (single antenna). RF Port 1 is enabled by checking the MIMO

selection during system configuration. A pair of N-to-TNC coaxial jumper cables are

provided to connect the RDL-2000 antenna system.

Figure 3: System - RDL-2000 RF Ports

2.3 Ground Connection

A ground-lug is provided on the RDL-2000 chassis for connection to the local grounding

system.

2.4 Antenna Alignment

The RDL-2000 features a built-in audible alignment tool to assist with pointing the

antenna. The Link Manager application or Telnet interface can provide assist in fine

alignment based on displaying real-time RSSI readings.

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 50 51

Sem comentários

Redline Communications RDL-2000 Manual do Utilizador Página 14